Filter
Top Products
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Switching Commands 3-126
v1.0, November 2010
no ip verify binding
Use this command to remove the IPSG static entry from the IPSG database.
ip dhcp snooping limit
Use this command to control the rate at which the DHCP Snooping messages come. The default
rate is 15 pps with a range from 0 to 30 pps. The default burst level is 1 second with a range of 1 to
15 seconds.
no ip dhcp snooping limit
Use this command to set the rate at which the DHCP Snooping messages come, and the burst level,
to the defaults.
Format ip verify binding <mac-address> vlan <vlan id> <ip address> interface
<interface id>
Mode Global Config
Format no ip verify binding <mac-address> vlan <vlan id> <ip address>
interface <interface id>
Mode Global Config
Default 15 pps for rate limiting and 1 sec for burst interval
Format ip dhcp snooping limit {rate pps [burst interval seconds]}
Mode Interface Config
Format no ip dhcp snooping limit
Mode Interface Config