Filter
Top Products
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Switching Commands 3-87
v1.0, November 2010
storm-control multicast level
This command configures the multicast storm recovery threshold for an interface as a percentage
of link speed and enables multicast storm recovery mode. If the mode is enabled, multicast storm
recovery is active, and if the rate of L2 multicast traffic ingressing on an interface increases
beyond the configured threshold, the traffic will be dropped. Therefore, the rate of multicast traffic
will be limited to the configured threshold.
no storm-control multicast level
This command sets the multicast storm recovery threshold to the default value for an interface and
disables multicast storm recovery.
storm-control multicast rate
Use this command to configure the multicast storm recovery threshold for an interface in packets
per second. If the mode is enabled, multicast storm recovery is active, and if the rate of L2
broadcast traffic ingressing on an interface increases beyond the configured threshold, the traffic is
dropped. Therefore, the rate of multicast traffic is limited to the configured threshold.
no storm-control multicast rate
This command sets the multicast storm recovery threshold to the default value for an interface and
disables multicast storm recovery.
Default 5
Format storm-control multicast level <0-100>
Mode Interface Config
Format no storm-control multicast level <0-100>
Mode Interface Config
Default 0
Format storm-control multicast rate <0-14880000>
Mode Interface Config