Filter
Top Products
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Management Commands 7-58
v1.0, November 2010
show trapflags
This command displays trap conditions. The command’s display shows all the enabled OSPFv2
and OSPFv3 trapflags. Configure which traps the switch should generate by enabling or disabling
the trap condition. If a trap condition is enabled and the condition is detected, the SNMP agent on
the switch sends the trap to all enabled trap receivers. You do not have to reset the switch to
implement the changes. Cold and warm start traps are always generated and cannot be disabled.
Format show trapflags
Mode Privileged EXEC
Term Definition
Authentication
Flag
Can be enabled or disabled. The factory default is enabled. Indicates whether
authentication failure traps will be sent.
Link Up/Down
Flag
Can be enabled or disabled. The factory default is enabled. Indicates whether link status
traps will be sent.
Multiple Users
Flag
Can be enabled or disabled. The factory default is enabled. Indicates whether a trap will
be sent when the same user ID is logged into the switch more than once at the same time
(either through Telnet or the serial port).
Spanning Tree
Flag
Can be enabled or disabled. The factory default is enabled. Indicates whether spanning
tree traps are sent.
ACL Traps May be enabled or disabled. The factory default is disabled. Indicates whether ACL traps
are sent.
DVMRP Traps Can be enabled or disabled. The factory default is disabled. Indicates whether DVMRP
traps are sent.
OSPFv2 Traps Can be enabled or disabled. The factory default is disabled. Indicates whether OSPF
traps are sent. If any of the OSPF trap flags are not enabled, then the command displays
disabled. Otherwise, the command shows all the enabled OSPF traps’ information.
OSPFv3 Traps Can be enabled or disabled. The factory default is disabled. Indicates whether OSPF
traps are sent. If any of the OSPFv3 trap flags are not enabled, then the command
displays disabled. Otherwise, the command shows all the enabled OSPFv3 traps’
information.
PIM Traps Can be enabled or disabled. The factory default is disabled. Indicates whether PIM traps
are sent.