Filter
Top Products
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Switching Commands 3-180
v1.0, November 2010
Source: local
Priority: low
show lldp med remote-device
This command displays summary information about remote devices that transmit current LLDP
MED data to the system. You can show information about LLDP remote data received on all ports
or on a specific port.
Example: The following shows example CLI display output for the command.
(Switch) #show lldp med remote-device all
LLDP MED Remote Device Summary
Local
Interface Remote ID Device Class
--------- --------- ------------
1/0/8 1 Class I
1/0/9 2 Not Defined
1/0/10 3 Class II
1/0/11 4 Class III
1/0/12 5 Network Con
Format show lldp med remote-device {<unit/slot/port> | all}
Mode Privileged EXEC
Term Definition
Interface The interface in a unit/slot/port format.
Device Class The Remote device’s MED Classification. There are four different kinds of devices, three
of them represent the actual end points (classified as Class I Generic [IP Communication
Controller etc.], Class II Media [Conference Bridge etc.], Class III Communication [IP
Telephone etc]). The fourth device is Network Connectivity Device, which is typically a
LAN Switch/Router, IEEE 802.1 Bridge, IEEE 802.11 Wireless Access Point etc.