Filter
Top Products
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Routing Commands 4-11
v1.0, November 2010
no ip route default
This command deletes all configured default routes. If the optional <nexthopip> parameter is
designated, the specific next hop is deleted from the configured default route and if the optional
preference value is designated, the preference of the configured default route is reset to its default.
ip route distance
This command sets the default distance (preference) for static routes. Lower route distance values
are preferred when determining the best route. The ip route and ip route default
commands allow you to optionally set the distance (preference) of an individual static route. The
default distance is used when no distance is specified in these commands. Changing the default
distance does not update the distance of existing static routes, even if they were assigned the
original default distance. The new default distance will only be applied to static routes created
after invoking the ip route distance command.
no ip route distance
This command sets the default static route preference value in the router. Lower route preference
values are preferred when determining the best route.
ip netdirbcast
This command enables the forwarding of network-directed broadcasts. When enabled, network
directed broadcasts are forwarded. When disabled they are dropped.
Format no ip route default [{<nexthopip> | <preference>}]
Mode Global Config
Default 1
Format ip route distance <1-255>
Mode Global Config
Format no ip route distance
Mode Global Config
Default disabled