Filter
Top Products
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Quality of Service (QoS) Commands 5-3
v1.0, November 2010
The <trafficclass> values can range from 0-6, although the actual number of available
traffic classes depends on the platform.
no classofservice ip-dscp-mapping
This command maps each IP DSCP value to its default internal traffic class value.
classofservice trust
This command sets the class of service trust mode of an interface. You can set the mode to trust
one of the Dot1p (802.1p), IP DSCP, or IP Precedence packet markings. You can also set the
interface mode to untrusted. If you configure an interface to use Dot1p, the mode does not appear
in the output of the show running config command because Dot1p is the default.
no classofservice trust
This command sets the interface mode to the default value.
Format classofservice ip-dscp-mapping <ipdscp> <trafficclass>
Mode Global Config
Format no classofservice ip-dscp-mapping
Mode Global Config
Note: The classofservice trust dot1p command will not be supported in future releases of
the software because Dot1p is the default value. Use the no classofservice trust
command to set the mode to the default value.
Default dot1p
Format classofservice trust {dot1p | ip-dscp | ip-precedence | untrusted}
Modes • Global Config
• Interface Config
Format no classofservice trust
Modes • Global Config
• Interface Config