NETGEAR XSM7224S-100NAS Switch User Manual


 
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Switching Commands 3-152
v1.0, November 2010
If a VLAN has IGMP Snooping Querier enabled and IGMP Snooping is operationally disabled on
it, IGMP Snooping Querier functionality is disabled on that VLAN. IGMP Snooping functionality
is re-enabled if IGMP Snooping is operational on the VLAN.
The IGMP Snooping Querier application supports sending periodic general queries on the VLAN
to solicit membership reports.
no set igmp querier
Use this command to disable IGMP Snooping Querier on the system. Use the optional address
parameter to reset the querier address to 0.0.0.0.
set igmp querier query-interval
Use this command to set the IGMP Querier Query Interval time. It is the amount of time in
seconds that the switch waits before sending another general query.
Note: The Querier IP Address assigned for a VLAN takes preference over global
configuration.
Default disabled
Format set igmp querier [<vlan-id>] [address ipv4_address]
Mode Global Config
VLAN Mode
Format no set igmp querier [<vlan-id>] [address]
Mode Global Config
VLAN Mode
Default disabled
Format set igmp querier query-interval <1-18000>
Mode Global Config