Filter
Top Products
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Management Commands 7-62
v1.0, November 2010
no radius server host
The
no version of this command deletes the configured server entry from the list of configured
RADIUS servers. If the RADIUS authenticating server being removed is the active server in the
servers that are identified by the same server name, then the RADIUS client selects another server
for making RADIUS transactions. If the 'auth' token is used, the previously configured RADIUS
authentication server is removed from the configuration. Similarly, if the 'acct' token is used, the
previously configured RADIUS accounting server is removed from the configuration. The
<ipaddr|dnsname> parameter must match the IP address or dns name of the previously
configured RADIUS authentication / accounting server.
The following shows an example of the command.
(Switch) (Config) #radius server host acct 192.168.37.60
(Switch) (Config) #radius server host acct 192.168.37.60 port 1813
(Switch) (Config) #radius server host auth 192.168.37.60 name
Network1_RADIUS_Auth_Server port 1813
(Switch) (Config) #radius server host acct 192.168.37.60 name
Network2_RADIUS_Auth_Server
(Switch) (Config) #no radius server host acct 192.168.37.60
radius server key
This command configures the key to be used in RADIUS client communication with the specified
server. Depending on whether the 'auth' or 'acct' token is used, the shared secret is configured for
the RADIUS authentication or RADIUS accounting server. The IP address or hostname provided
must match a previously configured server. When this command is executed, the secret is
prompted.
dnsname The DNS name of the server.
0-65535 The port number to use to connect to the specified RADIUS server.
servername The alias name to identify the server.
Format no radius server host {auth | acct} {<ipaddr|dnsname>}
Mode Global Config
Field Description