Filter
Top Products
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Quality of Service (QoS) Commands 5-41
v1.0, November 2010
ip access-list rename
This command changes the name of an IP Access Control List (ACL). The <name> parameter is
the names of an existing IP ACL. The <newname> parameter is a case-sensitive alphanumeric
string from 1 to 31 characters uniquely identifying the IP access list.
This command fails is an IP ACL by the name <newname> already exists.
{deny | permit} (IP ACL)
This command creates a new rule for the current IP access list. Each rule is appended to the list of
configured rules for the list.
A rule may either deny or permit traffic according to the specified classification fields. At a
minimum, either the every keyword or the protocol, source address, and destination address values
must be specified. The source and destination IP address fields may be specified using the
keyword ‘
any’ to indicate a match on any value in that field. The remaining command parameters
are all optional, but the most frequently used parameters appear in the same relative order as
shown in the command format.
Format ip access-list rename <name> <newname>
Mode Global Config
Note: The 'no' form of this command is not supported, since the rules within an IP ACL
cannot be deleted individually. Rather, the entire IP ACL must be deleted and re-
specified.
Note: An implicit 'deny all' IP rule always terminates the access list.
Note: For the XSM7224S, the mirror parameter allows the traffic matching this rule to
be copied to the specified <unit/slot/port>, while the redirect parameter
allows the traffic matching this rule to be forwarded to the specified <unit/
slot/port>. The assign-queue and redirect parameters are only valid
for a permit rule.