Filter
Top Products
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Utility Commands 6-15
v1.0, November 2010
show running-config
Use this command to display or capture the current setting of different protocol packages
supported on the switch. This command displays or captures commands with settings and
configurations that differ from the default value. To display or capture the commands with settings
and configurations that are equal to the default value, include the [all] option.
The output is displayed in script format, which can be used to configure another switch with the
same configuration. If the optional <scriptname> is provided with a file name extension of
“.scr”, the output is redirected to a script file.
If option <changed> is used, this command displays/capture commands with settings/
configurations that differ from the default value.
• If all the flags in a particular group are enabled, then the command displays trapflags
<group name> all.
• If some, but not all, of the flags in that group are enabled, the command displays trapflags
<groupname> <flag-name>.
Note: Show running-config does not display the User Password, even if you set one
different from the default.
Note: If you issue the show running-config command from a serial connection, access to
the switch through remote connections (such as Telnet) is suspended while the
output is being generated and displayed.
Note: If you use a text-based configuration file, the show running-config
command will only display configured physical interfaces, i.e. if any interface only
contains the default configuration, that interface will be skipped from the show
running-config command output. This is true for any configuration mode that
contains nothing but default configuration. That is, the command to enter a
particular config mode, followed immediately by its ‘exit’ command, are both
omitted from the show running-config command output (and hence from
the startup-config file when the system configuration is saved.)
Format show running-config [all | <scriptname> | changed]
Mode Privileged EXEC