Filter
Top Products
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Switching Commands 3-106
v1.0, November 2010
lacp partner system priority
Use this command to configure the administrative value of the priority associated with the
Partner’s System ID. The valid range for <priority> is 0 to 65535.
no lacp partner system priority
Use this command to configure the default administrative value of priority associated with the
Partner’s System ID.
port-channel static
This command enables the static mode on a port-channel (LAG) interface. By default the static
mode for a new port-channel is disabled, which means the port-channel is dynamic. However if the
maximum number of allowable dynamic port-channels are already present in the system, the static
mode for a new port-channel enabled, which means the port-channel is static.You can only use this
command on port-channel interfaces.
Default 0x0
Format lacp partner system priority <priority>
Mode Interface Config
Note: This command is only applicable to physical interfaces.
Format no lacp partner system priority
Mode Interface Config
Default disabled
Format port-channel static
Mode Interface Config