Filter
Top Products
Chapter 8 Advanced Copy Management
8.2 Functions in the Action Area for Advanced Copy
ETERNUS Web GUI User’s Guide
Copyright 2013 FUJITSU LIMITED P2X0-1090-10ENZ0
318
3 Click the [OK] button.
→ The specified copy parameters are registered.
4 Click the [Done] button to return to the [Snap Data Pool] screen.
End of procedure
8.2.12 Set Copy Path
This function sets copy path information between the ETERNUS Disk storage systems required for performing
REC using the wizard screen.
Copy path information indicates the path (copy path and the storage system where the copy path is set) used
for performing REC.
Not only copy path information of the local device but also the information between remote devices can be
created.
The following ETERNUS Disk storage systems support the [Set Copy Path] function.
• ETERNUS DX90 S2
• ETERNUS DX410 S2/DX440 S2
• ETERNUS DX8100 S2/DX8700 S2
• ETERNUS DX90
• ETERNUS DX410/DX440/DX8100/DX8400/DX8700
• ETERNUS4000/ETERNUS8000
• ETERNUS6000
In this section, the storage system that is used to create copy paths is referred to as "local device" and the
storage system that is connected to is referred to as a "remote device".
The following settings are available for the [Set Copy Path] function:
(1)Register Device Information (Register)
(2)Create Copy Path (Create)
(3)Save (Save)
(4)Apply Copy Path (Apply)
(5)Measure Round Trip Time (Measure)