Filter
Top Products
Chapter 9 Connectivity Management
9.2 Functions in the Action Area for Connectivity
ETERNUS Web GUI User’s Guide
Copyright 2013 FUJITSU LIMITED P2X0-1090-10ENZ0
542
The procedure to set iSCSI port parameters is as follows:
Procedure
1 Select which iSCSI port to set the parameters for (multiple selections can be made) and click
[Configure iSCSI Port] in [Action].
2 Set the parameters for all of the selected ports and click the [Set] button.
The settings of port parameters vary depending on the port type and the port mode ("When the port
mode is "CA"" (page 542), "When the port mode is "RA"" (page 548), "When the port mode is "CA/RA""
(page 554), or "When the port mode is "iSCSI-RA (for older storage system connection)"" (page 562)).
■ When the port mode is "CA"
When the type is "1G iSCSI" or "10G iSCSI" and the port mode is "CA", specify the following items:
● Select Port
• Port
Select the target port.
The selectable port locations are displayed as options:
- CM#x CA#y Port#z (x: CM number, y: CA number, z: Port number)
● TCP/IP Settings
• IP Version
Select the IP version for the target port.
- IPv4
Specify the IPv4 address. When "IPv4" is selected, input "IP Address" (required), "Subnet Mask"
(required), and "Gateway".
- IPv6
Specify the IPv6 address. When "IPv6" is selected, input "IPv6 Link Local Address" (required),
"IPv6 Connect IP Address", and "IPv6 Gateway".
- IPv4 / IPv6
Specify both the IPv4 address and the IPv6 address. The input items for IPv4 and IPv6 can be
specified.
• IP Address
Input the IPv4 address of the target port (required when "IPv4" is selected).
Click the [Test Connection (ping)] button to display the "[Send Ping Command] Screen" (page 565)
.
Specify the IP address to check the connection status of the connection destination storage system
and the number of transmissions. Click the [Send] button. When the "ping" command is sent, the
settings of the IP address and the connection path for the destination storage system can be
checked.
The same port mode can be selected for multiple "1G iSCSI" or "10G iSCSI" type iSCSI ports. Multiple
selections can also be made for the "iSCSI-RA (for older storage system connection)" type iSCSI ports.
When multiple ports are selected, select the target port and set the parameters for each port.