Filter
Top Products
Chapter 9 Connectivity Management
9.1 Connectivity Status
ETERNUS Web GUI User’s Guide
Copyright 2013 FUJITSU LIMITED P2X0-1090-10ENZ0
386
• Transfer Rate
The transfer speed of the target port is displayed.
- Auto-negotiation
- 1.5 Gbit/s
- 3 Gbit/s
- 6 Gbit/s
• Reset Scope
The reset scope of the target port is displayed.
Reset scope is the range where the command reset from the server is performed, when the target port is
connected to multiple servers.
- I_T_L (I: Initiator, T: Target, L: LUN)
Reset (cancel) the command request from the server that sent the command reset request.
- T_L (T: Target, L: LUN)
Reset (cancels) the command request from all of the servers that are connected to the port.
• Release Reservation if Chip is Reset
Whether the function to release the reservation status of the volume when the target port (chip) is reset is
enabled or disabled is displayed.
9.1.4.4 FCoE Port
Parameters of the FCoE ports that are registered in the ETERNUS DX Disk storage system are displayed.
The following items are displayed in the Main area:
• Port
The location information of the target port is displayed.
- CM#x CA#y Port#z (x: CM number, y: CA number, z: Port number)
• Type
The CA type (fixed at "FCoE") of the target port is displayed.
• Status
The status of the target port is displayed.
• Port Mode
The mode (fixed at "CA") of the target port is displayed.