Filter
Top Products
Chapter 9 Connectivity Management
9.2 Functions in the Action Area for Connectivity
ETERNUS Web GUI User’s Guide
Copyright 2013 FUJITSU LIMITED P2X0-1090-10ENZ0
602
The procedure to release Host-LU QoS is as follows:
Procedure
1 Select the "Host - CA Port - LUN Group" for which the Host-LU QoS is to be released (multiple
selections can be made) and click [Release Host-LU QoS] in [Action].
→ A confirmation screen appears.
2 Click the [OK] button.
→ Releasing of the Host-LU QoS starts.
3 Click the [Done] button to return to the [Host-LU QoS] screen.
End of procedure
9.2.7.4 Start Host-LU QoS Performance Monitoring
This function starts performance monitoring of Host-LU QoS.
Target ports for monitoring performance
• When this function is selected in the [Host-LU QoS] screen, performance monitoring of Host-LU QoS is
started for the following ports:
- All FC, iSCSI, SAS, and FCoE ports that are installed in the ETERNUS DX Disk storage system
- Ports which port mode are "CA" or "CA/RA"
- Ports without " Undefined" status or " Undefined (Error)" status
• When this function is selected in each [Port QoS] screen for FC, iSCSI, SAS, or FCoE, performance monitoring
of Host-LU QoS is started for the following ports:
- Ports that are selected in the [Port QoS] screen for each host interface (multiple selections can be
made)
When this function is started after port selection, ports with different host interfaces cannot be selected at
the same time.