Fujitsu DX8100 S2 Computer Drive User Manual


  Open as PDF
of 1066
 
Chapter 9 Connectivity Management
9.2 Functions in the Action Area for Connectivity
ETERNUS Web GUI User’s Guide
Copyright 2013 FUJITSU LIMITED P2X0-1090-10ENZ0
548
When the port mode is "RA"
When the type is "1G iSCSI" or "10G iSCSI" and the port mode is "RA", specify the following items:
Select Port
Port
Select the target port.
The selectable ports are displayed as options:
- CM#x CA#y Port#z (x: CM number, y: CA number, z: Port number)
TCP/IP Settings
IP Version
Select the IP version for the target port.
- IPv4
Specify the IPv4 address. When "IPv4" is selected, input "IP Address" (required), "Subnet Mask"
(required), and "Gateway".
- IPv6
Specify the IPv6 address. When "IPv6" is selected, input "IPv6 Link Local Address" (required),
"IPv6 Connect IP Address", and "IPv6 Gateway".
- IPv4 / IPv6
Specify both the IPv4 address and the IPv6 address. The input items for IPv4 and IPv6 can be
specified.
IP Address
Input the IPv4 address of the target port (required when "IPv4" is selected).
Click the [Test Connection (ping)] button to display the "[Send Ping Command] Screen" (page 565)
.
Specify the IP address to check the connection status of the connection destination storage system
and the number of transmissions. Click the [Send] button. When the "ping" command is sent, the
settings of the IP address and the connection path for the destination storage system can be
checked.
Data transmission might fail when "Header Digest" or "Data Digest" is enabled. In this case, select
"OFF" for "Header Digest" and "Data Digest".