Chapter 9 Connectivity Management
9.2 Functions in the Action Area for Connectivity
ETERNUS Web GUI User’s Guide
Copyright 2013 FUJITSU LIMITED P2X0-1090-10ENZ0
613
4 Click the [Done] button to return to the [iSCSI Port QoS] screen.
9.2.7.11 Set SAS Port QoS
This function specifies the bandwidth limit (maximum performance limit) for the SAS port.
The procedure to set the SAS port QoS is as follows:
1 Select the SAS port to set the bandwidth limit (multiple selections can be made), and click
[Set SAS Port QoS] in [Action].
This function can be used, irrespective of whether the Host-LU QoS is enabled or disabled. However, if the
Host-LU QoS has been disabled, the host starts operating within the configured bandwidth limit after the
Host-LU QoS is enabled.
• Configure the port bandwidth limit on each host. Refer to the following sections for details:
- "9.2.7.6 Set FC/FCoE Host QoS" (page 605)
- "9.2.7.7 Set iSCSI Host QoS" (page 607)
- "9.2.7.8 Set SAS Host QoS" (page 608)
• The LUN bandwidth limit can be configured in the LU QoS group. Refer to "9.2.7.2 Set Host-LU QoS" (page
599) for details.
