Filter
Top Products
Chapter 10 Component Management
10.2 Functions in the Action Area for Component
ETERNUS Web GUI User’s Guide
Copyright 2013 FUJITSU LIMITED P2X0-1090-10ENZ0
699
■ Turning off the LED
The procedure to turn off an LED is as follows:
Procedure
1 Click [Turn off locator beacon] in [Action].
→ A confirmation screen appears.
2 Click the [OK] button.
→ The locator beacon is turned off.
3 Click the [Done] button to return to the [Controller Enclosure] screen.
End of procedure
10.2.3 Add Channel Adapter Port
This function enables a CA port to be added without stopping the ETERNUS DX Disk storage system.
If the LED is already turned off, [Turn off locator beacon] cannot be selected.
• This function is available only for the ETERNUS DX80 S2 model that is using one port for each CM.
• CA ports for FC, iSCSI, FCoE, or SAS, host interfaces can be added.
• When the general status of the ETERNUS DX Disk storage system is not normal, a CA port cannot be
added.
The 1-port type CA is also displayed as a 2-port type. To determine whether the CA is 1-port type or 2-port-
type, refer to the port number displayed in the [Internal Parts] tab in the "10.1.6 Channel Adapter Detail"
(page 655). Note that 1-port type CAs are not available in some regions.