Filter
Top Products
Chapter 11 System Management
11.2 Functions in the Action Area for System
ETERNUS Web GUI User’s Guide
Copyright 2013 FUJITSU LIMITED P2X0-1090-10ENZ0
903
11.2.10.2 Disable Audit Log
This function disables the audit log function.
The procedure to disable the audit log function is as follows:
Procedure
1 Click [Disable Audit Log] in [Action].
→ A confirmation screen appears.
2 Click the [OK] button.
→ Disabling of the audit log starts.
3 Click the [Done] button to return to the [Audit Log] screen.
End of procedure
11.2.10.3 Setup Audit Log
This function sets up external servers (Syslog servers) for sending audit logs that are detected by the ETERNUS
DX Disk storage system.
Up to two Syslog servers can be registered.
If the audit log function has already been disabled, [Disable Audit Log] cannot be clicked.
• Enable the "Audit Log" setting, and then configure the destination Syslog server. Audit logs are sent after
the Syslog server is specified.
• Confirm that the audit log has been successfully sent to the Syslog server by logging in and out from GUI
or CLI and performing a transmission test to the Syslog server.
• Even if a communication error occurs between the ETERNUS DX Disk storage system and the Syslog server,
the audit log is not sent again.
• Changing the Syslog server setting is only available when the "Audit Log" setting is "Enable". Note that
once "on" is selected for the "Send Audit Log" setting, the "Send Audit Log" setting cannot be changed to
"off" for both of the Syslog servers (at least one Syslog server must be "on").