Filter
Top Products
Chapter 11 System Management
11.2 Functions in the Action Area for System
ETERNUS Web GUI User’s Guide
Copyright 2013 FUJITSU LIMITED P2X0-1090-10ENZ0
784
The procedure to set up the Syslog is as follows:
Procedure
1 Click [Setup Syslog] in [Action].
2 Specify the parameters, and click the [Set] button.
• Send Log
Select from "on (RFC3164)", "on (RFC5424)", or "off" for Syslog sending.
Logs are send in the selected RFC message format.
• Domain Name / IP Address
Input the domain name or the IP address of the Syslog server.
There are two methods to specify an IP address; "IPv4" and "IPv6". The following IPv6 addresses can
be used; "link local address", "global address", "unique local address", and "6to4 address". Refer to
"Available IPv6 Address" (page 757)
for details.
When the current setting is displayed, the IPv6 address is displayed as an abbreviation.
The following input conditions apply:
- For "Domain Name"
Up to 63 alphanumeric characters and symbols
- For IPv4 address
xxx.xxx.xxx.xxx
xxx: 1 - 255 for the top field (decimal)
xxx: 0 - 255 for other fields (decimal)
- For IPv6 address
xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx
xxxx: 0 - ffff (FFFF) (hexadecimal, alphanumeric characters)
Refer to "IPv6 Address Notation" (page 378)
for details.
• Port No.
Input the port number used to send a Syslog.
The following input conditions apply:
- Numeric characters
- "1" - "65535"
• Select whether to send ("on") or not send ("off") Syslogs for each ETERNUS DX Disk storage system.
• Confirm that the Syslog has been successfully sent to the Syslog server by logging in and out from GUI or
CLI and performing a transmission test to the Syslog server.
• Even if a communication error occurs between the ETERNUS DX Disk storage system and the Syslog server,
the Syslog is not sent again.
• Use the procedure in "11.2.9.1 Setup Event Notification" (page 880) for specifying events to be notified as
a Syslog.
• Syslogs are sent to both Syslog servers at the same time.
• The parameter settings for Syslog remain even when the "Send Log" setting is changed to "off".