Filter
Top Products
Chapter 3 Initial Setup
3.2 Initial Setup 2
ETERNUS Web GUI User’s Guide
Copyright 2013 FUJITSU LIMITED P2X0-1090-10ENZ0
49
3.2 Initial Setup 2
This sets the various reports that are generated when an error occurs in the ETERNUS DX Disk storage system.
If monitoring the ETERNUS DX Disk storage system, use this wizard to build an environment.
The flow of wizard operations in Initial Setup 2 is shown below.
(1)Set SNMP Agent Basic
Set up the SNMP Agent basic interface in the ETERNUS DX Disk storage system. Refer to "11.2.3.3 Setup
SNMP Agent Basic Interface" (page 761) for details.
(2)Set SNMP Manager
Specify the IP address of the SNMP Manager. Refer to "11.2.3.4 Setup SNMP Manager" (page 763)
for
details.
(3)Set SNMP Agent MIB Access View
Set the MIB View of the SNMP Agent. Refer to "11.2.3.5 Setup SNMP Agent MIB Access View" (page 766)
for
details.
(4)Set SNMP Agent User
Set up the SNMP Agent User.
Set the security levels and the MIB access view for each user. Refer to "11.2.3.6 Setup SNMP Agent User"
(page 768) for details.
(5)Set SNMP Agent Community
Set up the SNMP Agent Community. Refer to "11.2.3.7 Setup SNMP Agent Community" (page 771)
for
details.
(6)Set SNMP Agent Trap
Set up the environment to send notification of events that occur in the ETERNUS DX Disk storage system to
the SNMP Manager by an SNMP Trap. Refer to "11.2.3.8 Setup SNMP Agent Trap" (page 774)
for details.
(7)Set E-Mail Notification
Set the E-mail notification for events that occur in the ETERNUS DX Disk storage system. Refer to "11.2.3.12
Setup E-Mail Notification" (page 781) for details.
(8)Set Syslog Notification
Set up external servers (Syslog server) for sending logs of events that are detected by the ETERNUS DX Disk
storage system. Refer to "11.2.3.13 Setup Syslog" (page 783)
for details.
Some functions do not need to be specified depending on the SNMP version.
This setting is not required when SNMPv1 or SNMPv2c is used for SNMP communication.
This setting is not required when SNMPv3 is used for SNMP communication.