Filter
Top Products
Chapter 9 Connectivity Management
9.2 Functions in the Action Area for Connectivity
ETERNUS Web GUI User’s Guide
Copyright 2013 FUJITSU LIMITED P2X0-1090-10ENZ0
541
3 Click the [OK] button.
→ Modification of the FC port parameters starts.
4 Click the [Done] button to return to the [FC Port Group] screen.
End of procedure
9.2.3.8 Modify iSCSI Port Parameters
This function sets the connection information for the iSCSI ports that connect the ETERNUS DX Disk storage
system and the host or local and remote ETERNUS DX Disk storage systems.
• If the Loop ID is changed while a PRIMEPOWER server is operating, reboot the server immediately.
If the parameters do not satisfy the input conditions, an error screen appears.
• If some parameters do not satisfy the input conditions, an error screen appears.
When changing port parameters during operation, stop access from the server that is allocated to the target
port. Host access does not need to be stopped to change the port parameters of newly added CA ports.
• There are three port modes for an iSCSI port; CA, RA, and CA/RA. CA is used for connecting to a server, RA
is used for REC, and CA/RA is used for connecting to a server and for REC. To switch the port mode, refer to
"9.2.3.11 Modify Port Mode" (page 571)
. The default value is "CA".
• iSCSI-RA is a dedicated adapter that is used for REC between the local device and the ETERNUS DX400
series, the ETERNUS DX8000 series, the ETERNUS4000, or the ETERNUS8000.
• For more details on iSCSI-CA parameter settings, refer to "User’s Guide -Server Connection-" for each OS
type.