Filter
Top Products
Configuration 3: R8si<—x.25 —> R8r Gateway
<—ethernet—> R8si
105
Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000 CID: 77730
3 C-LAN Administration
> Submit the screen
End
Name: Information-only; appears in list generated by the “list data
module” command.
COS:
The values for these fields will be specified by the system
administrator.
COR:
TN:
DTE/DCE: The DTE/DCE assignments must be opposites on the two ends
of the connection. Use dce for node 2.
Enable Link? Set to y after the processor channels have been assigned.
Remote
Loop-Around
Test?
Set to
n unless testing.
Destination
Number:
external is used when connecting an r-model to an si-model.
For an r-to-r connection, enter the TAC+extension.
Establish
Connection?
y means that this switch will be responsible for the call setup
for this connection. Enter n when administering the data
module for Switch 2.
Connected
Data Module
Extension of node-2 data module.
Error Logging? Set to
n for normal operations.
Set to
y for testing — logs all data module errors.
Permanent
Virtual Circuit?
Always
y for DCS, CMS, and Intuity AUDIX.
Switched
Virtual Circuit?
Always
n for DCS, CMS, and Intuity AUDIX.
Highest PVC
Logical
Channel:
Set to 64 (the default) for normal operations.
Field Conditions/Comments
2 of 2