Filter
Top Products
Configuration 3: R8si<—x.25 —> R8r Gateway
<—ethernet—> R8si
111
Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000 CID: 77730
3 C-LAN Administration
Interface Chan For TCP/IP, interface channel numbers are in the range 5000
– 64500.
The recommended values are: 5001 for CMS, 5002 for Intuity
AUDIX, and 5003 for DCS connections that are not
gateways. These three values should be reused for multiple
instances of these applications; for example, if there are two
Intuity AUDIX’s, use 5002 for both; or if there are four
DEFINITY ECS’s, use 5003 for all four. The combination of
Link, Interface Channel, and Mach ID must be unique.
Destination Node Name of the far-end node for this channel. This must be a
name entered on the Node Names screen.
Destination Port A value of 0 allows any available interface channel on the
destination node to be used for this connection. The Interface
Channel number on the Switch-3 Processor Channel screen
must also be set to 0.
Session - Local For each connection, the Local Session number on this switch
must equal the Remote Session number on the remote switch
and vice versa.
Session - Remote
Mach ID Destination switch ID identified on the dial plan of the
destination switch.
Processor Channel 32: (The Ethernet side of the gateway)
Enable Set to y.
Appl. Use gtwy-tcp for conversion between X.25 and TCP/IP.
Gateway To Indicates a software connection between processor channels
32 and 23.
Mode Node-1 is the “server” for this session. Set node-3 to “client”
(c).
Interface Link This must match the link number assigned on the data module
screen.
Interface Chan For TCP/IP, interface channel numbers are in the range 5000
– 64500.
The recommended values are: 5001 for CMS, 5002 for Intuity
AUDIX, and 5003 for DCS connections that are not
gateways. The combination of Link, Interface Channel, and
Mach ID must be unique.
The recommended values for gateway switches is
6001–6099. The interface channel number must be unique for
each gateway.
Destination Node Name of the far-end node for this channel. This must be a
name entered on the Node Names screen.
Field Conditions/Comments
3 of 4