Filter
Top Products
IP Trunk Administration F IP Trunk Installation and
Administration
Administration for Network Connectivity
CID: 77730 555-233-504 — Issue 1 — April 2000
426
Confirming the number of available ports
To confirm that all ports allowed under your license are available, start at the
Windows NT desktop:
1 Double-click the Configuration Manager icon.
IP Trunk Configuration Manager appears.
2 Click the Telephony tab.
The Telephony property page appears.
3 Click Show All Ports.
Verify that the number of enabled port matches the maximum your license allows.
If not, contact your Lucent representative.
4 Click OK to close Configuration Manager.
NT administration procedures
The following procedures must be performed on the NT server to administer IP Trunks.
Administer call routing
parameters on
Configuration Manager
Outgoing calls
To administer routing for outgoing (originating) calls, start at the Windows NT
desktop:
1 Double-click the Configuration Manager icon.
IP Trunk Configuration Manager appears.
2 Click the Telephony tab.
The Telephony property page appears.
3 In the Maximum Digits to be collected box, type the number of digits that the
switch will forward to the IP Trunk software.
The Maximum Digits to be collected field entry will be determined by the type of
dialing, or types of dialing that will be performed using IP Trunking. Refer to the
Dial/Routing Plan Worksheets, or if extension dialing is used, this field would be
the extension length in the DEFINITY private network.
!
CAUTION:
Set this field no higher than the maximum length of the digit string the switch
sends. Otherwise, the IP Trunk application waits several seconds for
additional digits and users experience delays.
4 Click the Dial/Routing Plan tab.