Filter
Top Products
Configuration 2: R7r (+CMS) <—ethernet—> R7csi 3 C-LAN Administration
Administration for Network Connectivity
CID: 77730 555-233-504 — Issue 1 — April 2000
76
Switch 1 Task — Assign Node Names
This task assigns node names and IP addresses to each node in the network. This
screen is administered on Switch 1. A Node Names screen must be administered on
each switch in the network.
The node names and IP addresses in any network should be assigned in a logical and
consistent manner from the point of view of the whole network. These names and
addresses should be assigned in the planning stages of the network and should be
available from the customer system administrator or a Lucent representative.
Note: Enter node names for Intuity AUDIX and MSA adjuncts on page 1. Enter
node names for switches, routers, and CMS starting on page 2.
Begin
Steps
> Open Node Names form — enter ch node-n
> Go to page 2
> Enter values.
> Submit the screen
End
change node names Page 2 of 6
NODE NAMES
Name IP Address Name IP Address
default
_________ 0__.0__.0__.0__ _______________ ___.___.___.___
node-1 __ 192.168.1 _.124 _______________ ___.___.___.___
node-2___
192.168.1 _.125 _______________ ___.___.___.___
node-3_____
_____ 192.168.1 _.97_ _______________ ___.___.___.___
node-5__________ 192.168.1 _.51_ _______________ ___.___.___.___
Field Conditions/Comments
Name: Enter node names for the following 4 nodes:
• node-1: C-LAN Ethernet port on Switch 1
• node-2: CMS node (for consistency, use the host name of the
CMS computer assigned during the CMS setup procedure —
see CentreVu CMS Software Installation and Setup,
585-215-866)
• node-3: Interface on the router to the subnet of Switch 1.
• node-5: C-LAN Ethernet port on Switch 2.
IP Address: The unique IP addresses for the nodes named in the previous field.
See the description of the Subnet Mask field in the next task for
information on valid IP addresses.