Filter
Top Products
Configuration 1: R8r <—ppp—> R8si 3 C-LAN Administration
Administration for Network Connectivity
CID: 77730 555-233-504 — Issue 1 — April 2000
68
Switch 2 Task — Assign Link via ppp Data Module to Switch 1
This task administers a ppp data module on Switch 2 for the ppp connection to Switch
1. The data module defines a network interface — it associates a link number with a
port address and node name for the C-LAN port on Switch 2. It also specifies the
node name for the destination node, which is a C-LAN port on Switch 1.
Begin
Steps
>
Open Data Module form — enter ad da n
[This data module is assigned the next available extension, 3020.]
>Enter values
add data-module next
Page 1 of x
DATA MODULE
Data Extension: 3020 Name: _ppp on link 3 to node-1___ BCC: 2
Type: ppp COS: 1
Port: 01a1206 COR: 1
Link: 3_ TN: 1
Enable Link? n
Node Name: node-2_ ____
Subnet Mask: 255.255.255.0
Establish Connection: n
DESTINATION
Digits: __________
Node Name: node-1___
______
CHAP? n
Field Conditions/Comments
Type: This indicates the data-module type for this link.
Port: In this example, the C-LAN circuit pack is in slot 01a12; the ppp
connection is through port 06.
Link: The link number must be in the range 1 – 25, not previously
assigned on this switch.
Enable Link? If you need to add an IP route that uses this node as a gateway,
this field must be set to
y before adding the IP route. Otherwise
leave this field set to
n until the link administration is complete;
that is, until after all data modules and the processor channels
are assigned, then set to
y.
Name: Information-only; appears in list generated by the “list data
module” command.
1 of 2