Filter
Top Products
IP Trunk Administration
431
Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000 CID: 77730
F IP Trunk Installation and
Administration
For example, the code numbers 01, 02, ..., were prepended to the dialed string in
the originating switch. For each line number, the code number is entered in the
Search Digits field (as in the display above) as a unique digit string associated
with the line number. Since the code number is not intended to be routed to the
DEFINITY to complete the call, none is entered in the Replace Digits filed to
prevent digit replacement. Remember, the digits prepended at the originating end
and searched for at the terminating end must be the same.
Note: Any digits searched for must also be replaced if they are used to complete
the routing of a call. If digit substitution will be needed, it may be
necessary to put a digit string in the Search Digits field, and substitute
those with new digits in the Replace Digits field.
7 For Entry Type, enter accept to allow incoming calls.
8 In the Search Digits field, type the digits entered in the Terminating Search string
box for this site in the Dial/Routing Plan Worksheets, or follow the Procedures for
Extension Dialing Between Sites.
9 In the Replace Digits field, type the digits entered in the Terminating Replace
string box for this site in the Dial/Routing Plan Worksheets, or follow the
Procedures for Extension Dialing Between Sites.
10 Click OK.
The Add Terminating Entry dialog box closes, and the Dial/Routing Plan property
page appears showing the information you entered.
11 Repeat the above steps for each terminating entry (line or dialed string) specified
in the Dial/Routing Plan Worksheets and/or the Procedures for Extension Dialing
Between Sites.
12 Click OK to save your changes and close Configuration Manager.
The Dial/Routing Plan on the remote switch must be administered for the Originating
and Terminating Routing Info in a similar manner.
The IP Trunk software is now configured without restrictions on remote access.
Stopping IP Trunk
service
Note: Before you stop IP Trunk service, you must busy out the IP trunk group
on the DEFINITY ECS; then, after you restart IP Trunk service, release
the IP trunk group.
To stop IP Trunk service:
1 Busy out the IP trunk group on DEFINITY ECS.
2 Open the Windows NT Control Panel.
3 Double-click Services.
The Services dialog box appears.
4 In the Service column, select IP Trunk Service.
5 Click Stop.
Started disappears and the Status column does not show an entry beside Internet
Telephony Server.
6 Click Close.