Filter
Top Products
E C-LAN Installation
Administration for Network Connectivity
CID: 77730 555-233-504 — Issue 1 — April 2000
414
Install the C-LAN Circuit Pack
The following sections describe the steps for installing the C-LAN circuit pack.
Insert C-LAN Circuit
Packs
TCP/IP connections (10BaseT ethernet or ppp) require a TN799 C-LAN circuit pack.
Complete the following steps to install these circuit packs.
1 Determine the carrier/slot assignments of the circuit packs to be added. Both
types of circuit pack can go into any port slot with the following exceptions —
The C-LAN circuit pack cannot be installed in the A carrier for
~ the r model
~ a duplicated si model
2 Insert the circuit packs into the slots specified in step 1. You do not need to power
down the cabinet to install a C-LAN circuit pack.
Administer the C-LAN
Bus Bridge for csi
models
For the csi model only, complete the following steps to administer the Bus Bridge for
the new C-LAN circuit pack.
Note: If there are 2 C-LAN circuit packs installed in this csi switch, administer
the Bus Bridge for only one of them.
1 Enter change system-parameters maintenance.
2 At the bottom of Page 2, enter y in the Packet Intf2 field.
3 Enter the location of the C-LAN circuit pack in the Bus Bridge field (for example,
01a08 for cabinet 1, carrier A, and slot 8).
4 Enter the port bandwidths or use the defaults in the Pt0, Pt1, and Pt2 Inter-Board
Link Timeslots fields.
5 Submit the form.
6 Verify that the bus bridge LED is lit on the C-LAN circuit pack. This indicates
that the packet bus is enabled.
Test the Packet Bus
and C-LAN Circuit
Pack
To test the packet bus and the TN799 C-LAN circuit pack, the cabinet needs a
TN771D Maintenance/Test circuit pack.
1 If there is no TN771D circuit pack in the cabinet, place one in a port slot.
2 Enter test pkt port-network 1 long. For more information about these tests,
refer to the “test pkt command” section in the maintenance book.
3 If the TN771D circuit pack was already in the cabinet, leave it there.
4 If you added the TN771D circuit pack to the cabinet in order to test the TN799
circuit pack, remove it from the cabinet.