Filter
Top Products
Centralized Voice Mail Via Mode Code B Private Networking
Administration for Network Connectivity
CID: 77730 555-233-504 — Issue 1 — April 2000
398
10 On page 2, verify fields as follows:
~ Leave Word Calling Send a Message
field is #90.
~ Leave Word Calling Cancel a Message field is
#91.
Note: All nodes in the system and the Voice Mail system must match this
setting
11 For each DEFINITY node, enter add ds1
UUCSS
on the command line, where
UUCSS
is the address of the DS1 circuit pack.
12 On page 1, verify fields as follows:
~ Line Code
field is B8ZS.
~ Framing field is
extended superframe.
~ Signaling Mode field is
ISDN/PRI.
~ Connect field is
PBX.
~ Interface field is
network (for the hub) and user (for the remote switch).
Note: Mode Codes will not work with D4 or SuperFrame
13 For each DEFINITY node, enter change sign next on the command line.
Administer the signaling group (see example in Chapter 4 of this document).
14 For each DEFINITY node, enter change isdn private-numbering, and verify
fields as follows:
~ Set Network Level field is
0
This setting overrides the signaling on the D channel, allowing the Message
Waiting lamp activation signal to be sent
15 On the DEFINITY node, enter change sys params mode-code on the
command line.
16 On the hub switch, set the VMS Hunt Group Extension field to the voice mail
hunt group extension.
17 On the remote switches, repeat Step 15. Enter the voice mail hunt group extension
in the Remote VMS Extension - First field.
18 For each DEFINITY node, enter change aar an on the command line.
19 Verify the following:
~ Call Type field is
lev0
20 On the hub switch, enter change station
extension
for each port extension in
the voice mail hunt group.
21 On Page 1, verify the following:
~ Type field is
vmi.