Filter
Top Products
Configuration 1: R8r <—ppp—> R8si
67
Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000 CID: 77730
3 C-LAN Administration
Switch 2 Task — Assign Node Names
This task assigns node names and IP addresses to each node in the network. This
screen is administered on Switch 2. A Node Names screen must be administered on
each switch in the network.
The node names and IP addresses in any network should be assigned in a logical and
consistent manner from the point of view of the whole network. These names and
addresses should be assigned in the planning stages of the network and should be
available from the customer system administrator or from a Lucent representative.
Note: Enter node names for Intuity AUDIX and MSA adjuncts on page 1. Enter
node names for switches, routers, and CMS starting on page 2.
Begin
Steps
> Open Node Names form — enter ch node-n
> Go to page 2 of the screen
> Enter values.
> Submit the screen
End
change node names
Page 2 of 6
NODE NAMES
Name IP Address Name IP Address
default_________ 0__.0__.0__.0__ __________________ ___.___.___.___
node-1 __
192.168.10_.31_ _______________ ___.___.___.___
node-2 ___
192.168.10_.32_ _______________ ___.___.___.___
________________ ___.___.___.___ _______________ ___.___.___.___
________________ ___.___.___.___ _______________ ___.___.___.___
Field Conditions/Comments
Name Enter unique node names for the following 2 nodes:
• C-LAN PPP port on Switch 2
• C-LAN PPP port on Switch 1.
IP Address The unique IP addresses of the nodes named in the previous
field.