Filter
Top Products
Configuration 5A: R8csi <—ppp—> R8r (one C-LAN)
<—ethernet—> R8si
163
Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000 CID: 77730
3 C-LAN Administration
Switch 2 Task — Assign IP Route to node-3
This task specifies an initial route for messages handled by node-2 that are destined
for node-3. An IP route is required for this route because there are intermediate nodes
between node-2 and node-3.
Begin
Steps
> Enable the ppp link on the node-2 data module screen:
ch da 3020, set Enable Link? to y.
>Open the IP Routing form — enter a ip n
[The system assigns the route number 1.]
> Enter values
> Submit the screen
End
add ip-route next Page 1 of 1
IP ROUTING
Route Number: 1
Destination Node: node-3____
Gateway: node-1-ppp
C-LAN Board: 1a04
Metric: 0
Field Conditions/Comments
Destination Node: The name of the node at the destination of this route.
Gateway: Node name of the gateway by which the destination node is
reached for this route.
C-LAN Board: The location of the C-LAN circuit pack that provides the
interface for this route.
Metric: Enter 0.
See IP Routing (page 251) in Appendix A for more
information on the use of the Metric field.