Filter
Top Products
Configuration 4: R8csi <—ISDN—> R8si Gateway
<—ppp—> R8csi
3 C-LAN Administration
Administration for Network Connectivity
CID: 77730 555-233-504 — Issue 1 — April 2000
126
Switch 1 Task — Assign Node Names
This task assigns node names and IP addresses to each node in the network. This
screen is administered on Switch 1. A Node Names screen must be administered on
each switch in the network.
The node names and IP addresses in any network should be assigned in a logical and
consistent manner from the point of view of the whole network. These names and
addresses should be assigned in the planning stages of the network and should be
available from the customer system administrator or from a Lucent representative.
Note: Enter node names for Intuity AUDIX and MSA adjuncts on page 1. Enter
node names for switches, routers, and CMS starting on page 2.
Begin
Steps
> Open Node Names form — enter ch node-n
> Go to page 2.
> Enter values.
> Submit the screen
End
change node-names
Page 2 of 6
NODE NAMES
Name IP Address Name IP Address
default_________ 0__.0__.0__.0__ _______________ ___.___.___.___
node-1 __
192.168.10_.101 _______________ ___.___.___.___
node-3___
192.168.10_.103 _______________ ___.___.___.___
________________ ___.___.___.___ _______________ ___.___.___.___
Field Conditions/Comments
Name Enter unique node names for the following 2 nodes:
• C-LAN PPP port on Switch 1
• C-LAN PPP port on Switch 3.
IP Address The unique IP addresses of the nodes named in the previous
field.