Filter
Top Products
Configuration 5B: R8csi <—ppp—> R8r (2 C-LANs)
<—ethernet—> R8si
185
Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000 CID: 77730
3 C-LAN Administration
Destination Node Name of the far-end node for this channel. This must be a
name entered on the Node Names screen. For ppp
connections, it must match the Destination Node Name
entered on the ppp Data Module screen.
Destination Port A value of 0 allows any available interface channel on the
destination node to be used for this connection. The Interface
Channel number on the Switch-2 Processor Channel screen
must also be set to 0.
Session - Local The Local and Remote Session numbers can be any value
between 1 and 256 (si model) or 384 (r model), but they must
be consistent between endpoints. For each connection, the
Local Session number on this switch must equal the Remote
Session number on the remote switch and vice versa.
It is allowed, and sometimes convenient, to use the same
number for the Local and Remote Session numbers. It is
allowed, but not recommended, to use the same Session
numbers for two or more connections.
Session - Remote
Mach ID Destination switch ID identified on the dial plan of the
destination switch.
Processor Channel 13: (ethernet connection to Switch 3)
Enable Set to y.
Appl. Set to dcs for DCS signaling.
Mode Node-1d is the “server” for this session. Set to node-3 to
“client” (c).
Interface Link This must match the link number assigned on the node -1d
data module screen.
Interface Chan or TCP/IP, interface channel numbers are in the range 5000 –
64500.
The recommended values are: 5001 for CMS, 5002 for Intuity
AUDIX, and 5003 for DCS connections that are not
gateways. These three values should be reused for multiple
instances of these applications. The combination of Link,
Interface Channel, and Mach ID must be unique.
This number must match the Destination Port number on the
Switch-3 Processor Channel screen
Destination Node Name of the far-end node for this channel. This must be a
name entered on the Node Names screen.
Destination Port A value of 0 allows any available interface channel on the
destination node to be used for this connection. The Interface
Channel number on the Switch-3 Processor Channel screen
must also be set to 0.
Field Conditions/Comments
2 of 3