Filter
Top Products
Networking Screens
245
Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000 CID: 77730
A Screens Reference
Networking Screens
Node Names
In this context, a node is defined as any of the following — a C-LAN port, a bridge or router, a CMS ethernet
port, or an Intuity AUDIX, or other MSA (Message Server Adjunct) network interface card. The AUDIX and
MSA node name and IP address must be entered on page 1 of the screen. The data for all other node types,
including CMS, must be entered on pages 2–6.
The Node Names form holds up to 8 Audix node names with up to 7 characters each, up to 7 MSA node names
(up to 7 characters each) on page 1. It holds up to 160 non-specific node names (up to 15 characters each) for
DCS, CMS, or bridge/router nodes, on pages 2–6.
The node names and IP addresses in any network should be assigned in a logical and consistent manner from the
point of view of the whole network. These names and addresses should be assigned in the planning stages of the
network and should be available from the customer system administrator or from a Lucent representative.
NOTE:
Enter node names for Intuity AUDIX and MSA adjuncts
on page 1.
Enter node names for CMS, switches, and routers
starting on page 2.
page 1
Audix or MSA Name Identifies the name of the AUDIX or Message Server Adjunct (MSA) node.
page 1 of 6
NODE NAMES
Audix Name IP address MSA Names IP Address
1. audix
_ ___.___.___.___ 1. msa__ _ ___.___.___.___
2. _______ ___.___.___.___ 2. _______ ___.___.___.___
3. _______ ___.___.___.___ 3. _______ ___.___.___.___
4. _______ ___.___.___.___ 4. _______ ___.___.___.___
5. _______ ___.___.___.___ 5. _______ ___.___.___.___
6. _______ ___.___.___.___ 6. _______ ___.___.___.___
7. _______ ___.___.___.___ 7. _______ ___.___.___.___
8. _______ ___.___.___.___
Valid entries Usage
1-7 alphanumeric characters with no
embedded spaces.
Defaults:
audix, msa (csi, si)
blank (r)
Used as a label for the associated IP
address. The node names must be unique
on each switch.