Filter
Top Products
H.323 Trunk Administration
33
Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000 CID: 77730
2 H.323 Trunks
H.323 Trunk Administration
This section describes the administration steps needed to setup H.323 trunks. The first subsection covers the
enabling administration that needs to be in place before the trunk administration can be done. The second
subsection gives a summary of the H.323 trunk administration and the last subsection gives the detailed steps.
The screens used for this administration are described in detail in Appendix A, Screens Reference.
Screen fields not mentioned here are administered as in previous releases.
Enabling Administration
Before you can administer an H.323 trunk, a few customer options and circuit pack parameters need to be
properly set. In addition, there are some optional maintenance and IP parameters that can be administered. These
enabling settings are summarized here.
Optional Features
(System Parameters
Customer Options)
The Optional Features screen must be administered by the init login. Open the screen
with the change command (ch sys cu) and set the following fields:
page 1
•
G3 Version
= V8
•
Maximum H.323 Trunks
= number purchased; must be greater than 0.
page 3
•
H.323 Trunk
s? = y
•
ISDN-PRI?
= y
Circuit Pack The C-LAN and IP Interface assembly circuit packs must be administered on the
Circuit Pack screen. Open the Circuit Pack screen with the change command (ch ci)
and enter the board codes in available port slots:
C-LAN
•
Code = TN799
• Sfx = B
• Name = C-LAN
IP Interface assembly — enter in a slot with at least two empty slot before it
•
Code = TN802
• Sfx = B
• Name = MAPD Board {entered automatically by system}
The two slots immediately before this slot are automatically populated as follows:
• Code = DSMAPD {displays automatically}
Change DSMAPD to MEDPRO {the IP Interface board defaults to the IP Trunk
mode, which is specified by the DSMAPD in this field. Changing this field to
MEDPRO changes the board’s mode to MEDPRO}
• Sfx = {blank}
• Name = Reserved - IP {displays automatically}