Filter
Top Products
H.323 Trunk Administration 2 H.323 Trunks
Administration for Network Connectivity
CID: 77730 555-233-504 — Issue 1 — April 2000
36
H.323 Trunk Administration — Task Summary
After the enabling administration is complete, you can administer the H.323 IP trunks. The screens and fields
that need to be administered are listed below.
NOTE: This is only a list of screens and the fields that need to be
administered. The values that need to be entered in these fields are
described in the next section.
Node names A node name and IP address must be entered on the Node Names screen for each
C-LAN and IP Interface board on the local switch. For each far-end node that the
H.323 trunks on the local switch will connect to, a node name and IP address must be
entered for the far-end gatekeeper, which is a C-LAN board if the far-end is a
DEFINITY switch. Enter values in these fields:
~ Node Name
~ IP Address
IP Interfaces Each DEFINITY switch in an IP network has one IP Interfaces screen. One line on
this screen must be administered for each C-LAN and each IP Interface board. Enter
values in these fields:
~ Network regions are interconnected?
~ Enable
~ Type
~ Slot
~ Code
~ Sfx
~ Node Name
~ Subnet Mask
~ Default Gateway Address
~ Region
Ethernet Data Module A data module screen, type ethernet, must be administered for each C-LAN board on
the switch. Enter values in these fields:
~ Type
~ Port
~ Link
~ Name
~ Network uses 1’s for broadcast address?