Lucent Technologies Release 8.2 Server User Manual


 
Japan TTC Q931-a Private Networking Protocols B Private Networking
Administration for Network Connectivity
CID: 77730 555-233-504 — Issue 1 — April 2000
402
Setting Up TTC Q931-a
Complete the following steps to set up TTC connections.
Begin
Steps
1
Verify that you have the appropriate DEFINITY circuit pack for integration
2 Enter “change system-parameters customer-options” on the command line of
your system administration screen.
3 On page 1, verify that the G3 Version field is V8 or later
4 On page 2, verify that ISDN-PRI field is y.
5 Administer the TTC DS-1 circuit pack.
Check for the following field entries:
~ Connect field — pbx
~ Interface — peer-master or peer-slave
~ Peer Protocol — TTC
~ D-channel: (This item must match between the local and receiving switches)
~ Channel Numbering — sequential or timeslot (This item must match between
the local and receiving switches)
6 Administer or check the TTC ISDN trunk group(s) associated with the DS1
circuit pack.
Check for the following field entries on page 1 of the Trunk Group screen:
~ Group type: isdn
~ Supplementary Service protocol — a
~ Outgoing Display? y
Check for the following field entries On page 2
~ Disconnect Supervision — y
~ Numbering format — public, private, unknown, unk-pvt
~ Send Called/Busy/Connected Number — y
~ Sending Calling Number — y
~ Send Name — n
End