Filter
Top Products
2-89
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
OL-18083-01
Chapter 2 Installing the Sun Solaris 10 Operating System
Loading the Sun Solaris 10 Operating Environment
This procedure un-mirrors the disk partitions and removes the DiskSuite application from the platform.
Use this procedure if a system has DiskSuite installed and you no longer wish to use CSCOh024 to
configure the second disk for the log and spool directories.
If the platform is configured with customer-specific information, be sure to back up this information
before the partitions are un-mirrored and DiskSuite is removed. Consult the appropriate document,
depending on the software installed.
Step 1 Log in as root. Use the metastat command to verify that the state of all the mirrors is Okay.
Step 2 Type the following commands to run the script and press Enter:
cd /opt/sun_install/DiskSuite
./rm_disksuite_1.sh
The ./rm_disksuite_1.sh command detaches the mirrored disks and restores the original disk partition
file in /etc/vfstab. The machine reboots after detaching the mirrored disks and restoring the original disk
partition file.
Step 3 Log in as root and change directory to /opt/sun_install/DiskSuite. Enter the following command:
cd /opt/sun_install/DiskSuite
Step 4 Run the script ./rm_disksuite_2.sh:
./rm_disksuite_2.sh
This script clears the disk mirrors and removes the DiskSuite software packages from the system.
Step 5 Enter the following command and press Enter to remove the package, CSCOh023:
pkgrm CSCOh023
Text similar to the following is displayed:
The following package is currently installed:
CSCOh023 Media Gateway Controller Solaris 10 DiskSuite
(sparc,i386) 3.0(6)
Do you want to remove this package? [y,n,?,q] y
...
Removal of <CSCOh023> was successful.
This completes the DiskSuite removal.
Installing the Log and Spool File Systems (CSCOh024)
Note This section applies to a Cisco PGW 2200 Softswitch host with 18-GB disk drives running the
Cisco PGW 2200 Softswitch software.
Note If the DiskSuite software is installed and configured, you must first follow the procedure in the
“Removing the Solstice DiskSuite” section on page 2-88 to remove the DiskSuite software before
configuring the second disk to be used for the log and spool file systems.