Cisco Systems PGW 2200 Switch User Manual


 
2-129
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
OL-18083-01
Chapter 2 Installing the Sun Solaris 10 Operating System
Loading the Sun Solaris 10 Operating Environment
installed with this package
NTP software is installed and configured. System reboot is required to activate it. Do you
want to reboot now?[yes|no]
Step 6 You must reboot your system for the changes to take effect. Type yes and press Enter:
Step 7 If you require ftp access to your Cisco PGW 2200 Softswitch by Cisco BAMS or some other product,
type the following command and press Enter:
svcadm enable ftp
Note If you need to disable the ftp communications software, use the svcadm disable ftp command.
If you need to determine the status of the ftp communications software, use the svcs -a | grep
ftp command.
The communications software installation is now complete. Go to Table 2-2 on page 2-72 if you want to
continue with the list for package installation.
Installing the Verification Test Suite Script Package (CSCOh021)
The Verification Test Suite (VTS) provides an optional script designed to test configured Sun Solaris 10
platforms used for Cisco PGW 2200 Softswitch, BAMS, and HSI products. VTS test instructions
support the following interface cards:
Sun GigaSwift Ethernet PCI card (order number X1150A)
Sun 10/100BT Ethernet PCI card (order number X1033)
Sun Quad Fast Ethernet PCI card (order number X1034A)
Perform all testing with a console log file enabled to capture everything entered at the console input and
displayed on the console output. One way to accomplish this is through a terminal server connected to
the console port of your platform. You can use the xterm program with the -l –lf <logfile> command line
option to create the console log file.
For each target system in the test below, you should archive the console log file along with the VTS log
file created with other records.
Note This VTS package is not supported by the Sun Fire X4600, the Sun Fire X4600 M2, or the Sun Netra
X4200 M2 platform.
To install the VTS script package:
Step 1 Place the Cisco Solaris 10 Operating Environment CD in the CD-ROM drive of the target system.
Step 2 Type the following commands to install the VTS script package and press Enter:
# cd /cdrom/cdrom0
# pkgadd –d CSCOh021.pkg
Text similar to the following is displayed:
The following packages are available: