Filter
Top Products
A-17
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
OL-18083-01
Appendix A XECfgParm.dat File Parameters
Understanding the XECfgParm.dat File Format
*.sipFailover Specifies whether the Cisco PGW 2200 Softswitch hosts,
when connected with a session interrupt protocol (SIP)
network, should perform an automatic switchover when a
LAN interface fails.
Default: false
Valid values: true or false
*.sipRoutingMode Defines the routing mode of Cisco PGW 2200 Softswitch,
strict router or loose router.
Valid Values:
• 0 = Strict Router
• 1 = Loose Router
Default: 0
*.sm_meas_baseaddr Indicates the memory size of the base address.
Default: 3400
Note Do not change this value.
*.stPort Port number used between peer components or processes.
Enter any unused port number (for example, 7000). If your
configuration uses a Cisco SLT, enter the port number on the
Cisco SLT.
Note If you have two Cisco PGW 2200 Softswitch hosts
in a failover configuration, enter a different number
for this value in the XECfgParm.dat file on the
secondary host (for example, 7001).
Note On a new configuration, we recommend that this
parameter be set to 0. This value allows the
Cisco ITP-L port to be defined using the PEERPORT
parameter of the SESSIONSET.
Note SESSIONSET reads the port value that is defined.
However, if an *.stPort value other than 0 is defined
in XECfgParm.dat (for example, *.stPort=7001),
the SESSIONSET value gets overridden by the value
in XECfgParm.dat.
*.SUA.maxSigServices Defines the maximum number of Signaling Connection
Control Part (SCCP) User Application (SUA) signaling
services. It also defines the maximum number of SUA
routing keys.
Value: 256
Note Do not change this value.
Table A-1 Cisco PGW 2200 Softswitch 9.x XECfgParm.dat File Configuration Parameters
Configuration Parameter Definition