Filter
Top Products
D-38
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
OL-18083-01
Appendix D Sample Installation Scripts
Sample Configured XECfgParm.dat Files for Cisco PGW 2200 Softswitch Release 9.6(1)
*.desiredPlatformState = master
*.virtualFaultTolerant = false # avoid prov-dply/sync on FT mode in egw
*.SysConnectDataAccess = true # true, establish conn. to Data Access
Subsystem
*.GWClearChannelAlgorithm = null # clear channel algorithm
*.SipToIsupInterworkingInd = 0 # 0= No Interworking Encountered
# 1= Interworking Encountered
*.ipAddrLocalA = 10.0.1.160 # MIGRATED
*.ipAddrLocalB = 10.128.1.5 # MIGRATED
*.ipAddrPeerA = 10.0.1.161 # MIGRATED
*.ipAddrPeerB = 10.128.1.6 # MIGRATED
*.IP_Addr1 = 10.0.1.160 # MIGRATED
*.IP_Addr2 = 10.128.1.5 # MIGRATED
*.IP_Addr3 = 10.82.82.11 # MIGRATED
*.IP_Addr4 = 0.0.0.0 # MIGRATED
# These are Next Hop (router) IP Addresses
# They should be used when the Next Hop address(es)
# are different on the two MGC hosts
*.IP_NextHop1 = 0.0.0.0
*.IP_NextHop2 = 0.0.0.0
*.IP_NextHop3 = 0.0.0.0
*.IP_NextHop4 = 0.0.0.0
*.IP_NextHop5 = 0.0.0.0
*.IP_NextHop6 = 0.0.0.0
*.IP_NextHop7 = 0.0.0.0
*.IP_NextHop8 = 0.0.0.0
################################################################
# Improved SIP Failover Support. Setting 0.0.0.0 to both will disable
# the SIP Improved failover support Feature. Configuring only one will
# cause the switchover, if the physical interface where it present fails.
#
*.Virtual_IP_Addr1 = 0.0.0.0 # Must be from *.IP_Addr1 Subnet.
*.Virtual_IP_Addr2 = 0.0.0.0 # Must be from *.IP_Addr2 Subnet.
################################################################
*.geoSeparation = false # Geographical separated? or not.
*.sipFailover = false # Failover if SIP Service fails.
*.stPort = 7001 # MIGRATED
engine.SysVirtualSwitch = 0 # MIGRATED
pom.dataSync = true # MIGRATED
foverd.ipLocalPortA = 1052 # MIGRATED
foverd.ipPeerPortA = 1051 # MIGRATED
foverd.ipLocalPortB = 1054 # MIGRATED
foverd.ipPeerPortB = 1053 # MIGRATED
*.numberOfThreads = 1
#############################
# Sub System component version
*.subSysCompVer = 10.a
#############################
#------------------
# CVT Parameters
#------------------
#*.OwnClli = TTTT-SS-BB-XXX
#*.OwnClli = 1-22-33-444
# REQUIRED STARTUP PARAMETERS