Filter
Top Products
A-37
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
OL-18083-01
Appendix A XECfgParm.dat File Parameters
Understanding the XECfgParm.dat File Format
logger.fileRotateInterval Triggers a file rotation based on the time elapsed since the
previous rotation.
Default: 1440 minutes (24 hours)
Note This timer is reset after any rotation occurs,
regardless of the cause or trigger of the rotation.
logger.fileRotateSize Triggers a file rotation based on the size of the active file. A
file rotation triggered by this parameter also resets the
logger.fileRotateInterval timer.
Default: 100MB
Note The file size can grow larger than this parameter
indicates due to the verbosity of the logging levels
currently in effect.
logger.numThreads Determines whether the PXE logger should run in a separate
thread from the rest of the application. A value of 0 runs the
logger synchronously with the application; a value of 1 runs
the logger in a separate thread.
Value: 0/1 (Values less than 0 get reset to 0; values greater
than 1 get reset to 1.)
Default: 0
maximumActionsInTransaction Sets the maximum number of actions in one H.248
Transaction.
Value: Any integer
Default: 64
maxNumH248Links Defines the maximum number of H.248 links that the
Cisco PGW 2200 Softswitch supports.
Values: Any integer
Default: 1000
MDLANumberScreening Invokes the standard A-number screening on the number in
the calling number parameter, regardless of whether the call
is redirected or not.
Setting the MDLANumberScreening parameter to its default
value 0 (zero) in the XECfgParm.dat file defaults all
screening actions exclusively to the original calling party
number (A-number). No screening is done on the number in
the redirecting number parameter.
Default value: 0 (zero)
Note To invoke the redirecting number screening feature,
set the value to 1 in the XEConfigParm.dat file
during initial Cisco PGW 2200 Softswitch software
configuration.
Table A-1 Cisco PGW 2200 Softswitch 9.x XECfgParm.dat File Configuration Parameters
Configuration Parameter Definition