Filter
Top Products
2-90
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
OL-18083-01
Chapter 2 Installing the Sun Solaris 10 Operating System
Loading the Sun Solaris 10 Operating Environment
To determine whether DiskSuite is installed and configured, run the /usr/sbin/metastat command. If the
command is found and it displays the status of mirrors, it indicates that DiskSuite is installed and
configured.
Note For the device names for each platform type, see Table 2-1 on page 2-3 (Device Names on Supported
Host Platforms).
This procedure enables you to move the log and spool file system to the second disk drive to increase
the capacity for log, alarm, measurement, and CDR files. This improves the performance of the host. If
CSCOh024 is not installed, your system continues to store log and spool files on the first disk drive. The
second disk is defined into two partitions:
• The first partition is the log partition and uses about 30 percent of the disk.
• The second partition is the spool partition that uses 50percent of the disk.
Table 2-3 and Table 2-4 shows sample partition tables for disks 1 and 2 for a Netra t 1400 with 18-GB
disk drives.
Note On disk drives larger than 18 GB, the swap space is 4 GB.
Table 2-3 18-GB Disk 1 Partition Table (Cisco PGW 2200 Softswitch with Log and Spool
Package)
Slice No.
Cisco PGW 2200 Softswitch Host
Slice Name Slice Size (GB)
0/ 1.00
1/var 1.40
2 0.00
3 0.00
4 0.00
5 /opt 12.00
6swap 2.00
7 0.00
Table 2-4 18-GB Disk 2 Partition Table (Cisco PGW 2200 Softswitch with Log and Spool
Package)
Slice No.
Cisco PGW 2200 Softswitch Host
Slice Name Slice Size (GB)
0/ 1.00
1swap 2.00
2 0.00
3 /opt/CiscoMGC/var/log 5.70
4 /opt/CiscoMGC/var/spool 9.00