Filter
Top Products
2-117
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
OL-18083-01
Chapter 2 Installing the Sun Solaris 10 Operating System
Loading the Sun Solaris 10 Operating Environment
Processing package instance <SUNWnfsskr> from </tmp>
Network File System (NFS) server kernel support (Root)(sparc) 11.10.0,REV=2005.01.21.15.53
Copyright 2007 Sun Microsystems, Inc. All rights reserved.
Use is subject to license terms.
Using </> as the package base directory.
## Processing package information.
## Processing system information.
3 package pathnames are already properly installed.
## Verifying package dependencies.
## Verifying disk space requirements.
## Checking for conflicts with packages already installed.
## Checking for setuid/setgid programs.
This package contains scripts which will be executed with super-user
...
Processing package instance <SUNWtftp> from </tmp>
Trivial File Transfer Server(sparc) 11.10.0,REV=2005.01.21.15.53
Copyright 2007 Sun Microsystems, Inc. All rights reserved.
...
Trivial File Transfer Server (Root)(sparc) 11.10.0,REV=2005.01.21.15.53
Copyright 2005 Sun Microsystems, Inc. All rights reserved.
NTP, (Root)(sparc) 11.10.0,REV=2005.01.21.15.53
Copyright 2005 Sun Microsystems, Inc. All rights reserved.
NTP, (Usr)(sparc) 11.10.0,REV=2005.01.21.15.53
Copyright 2005 Sun Microsystems, Inc. All rights reserved.
...
Installation of <SUNWntpu> was successful.
Enter the IP address of NTP server:
Step 5 Type the IP address for the NTP server used for your network and press Enter. Text similar to the
following is displayed:
NTP is configured and enabled. You can manually change the configuration by modifying
/etc/inet/ntp.conf and disable NTP by run 'svcadm enable ntp'
At any time, you may uninstall the software installed
by this package with the following commands:
cd /opt/sun_install/SolPkg
./uninstall_SolPkg.sh
which will uninstall all the solaris software
installed with this package
NTP software is installed and configured. System reboot is required to activate it. Do you
want to reboot now?[yes|no]
Step 6 You must reboot your system for the changes to take effect. Type yes and press Enter.
Step 7 If you require ftp access to your Cisco PGW 2200 Softswitch by Cisco BAMS or some other product,
type the following command and press Enter:
svcadm enable ftp