Filter
Top Products
3-2
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
OL-18083-01
Chapter 3 Installing the Cisco PGW 2200 Softswitch Software Release 9.8 and Higher
Before You Start
Cautions, Notes, and Tips
Caution To prevent the system from running out of disk space during installation and to avoid removal of data
files and databases to compensate, you must first verify that there is enough hard disk space to support
your intended installation. To get free space, you can delete the following files:
- Unnecessary log files (platform*.log)
- User-generated trace files (*.btr)
- Call detail record (CDR) files (.bin or .csv)
- Old *.tar files
- User-generated toolkit files (in the /var/cust_specific/toolkit directory)
Caution Be sure to follow the Cisco PGW 2200 Softswitch software installation sequence listed in “Installing the
Cisco PGW 2200 Softswitch Software Release 9.8 and Higher Releases” section on page 3-3.
Note If you modify any file in the /etc directory, you must reboot the Solaris 10 operating system for the
changes to take effect.
Note Monitor system output frequently for error messages during the installation process and correct any error
conditions before continuing with the installation.
Tip Allow for at least 2 hours to install the Sun Solaris 10 operating system and approximately 1 hour to
install the Cisco PGW 2200 Softswitch software.
Table 3-1 Installation Overview and Reference Sections
Condition Action
The Sun Solaris 10 operating system is not yet
installed, you must first install it.
Start with Chapter 2, “Installing the Sun Solaris
10 Operating System.”
The Sun Solaris 10 operating system is already
installed and you are installing the
Cisco PGW 2200 Softswitch software for the first
time.
Follow the procedures found in the “Installing the
Cisco PGW 2200 Softswitch Software Release
9.8 and Higher Releases” section on page 3-3.
The Sun Solaris 10 operating system is already
installed and you are upgrading a pre-release
version of the Cisco PGW 2200 Softswitch
software Release 9.8.
You must reinstall Sun Solaris 10. Start with
Chapter 2, “Installing the Sun Solaris 10
Operating System.”