Filter
Top Products
1-2
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
OL-18083-01
Chapter 1 Preparing for Sun Solaris Operating System and Cisco PGW 2200 Softswitch Software Installation
Solaris 10, Cisco PGW 2200 Softswitch Software Release 9.8 and Higher Software Release Preinstallation Checklists
Note The target machine must have a terminal connected to the console port by means of a serial cable.
Required Software Media
Gather all of the appropriate software media listed in Table 1-1. For more information, see the
appropriate Sun documentation that shipped with your system.
Minimum System Requirements
Refer to the Cisco PGW 2200 Softswitch Hardware Installation Guide (Release 7 & 9) for the host
minimum hardware requirements. Before using the minimum hardware configuration, consult your
Cisco representative to determine the hardware that gives you the best performance results based on your
network configuration, proposed traffic, and desired processing power.
Table 1-1 Solaris 10 Required Media Checklist
Media Version
The following CD-ROM disks are ordered from Cisco:
• Cisco Solaris 10 Operating System Jumpstart Disk
This disk installs the Sun Solaris 10 Operating System,
configured specifically to support the
Cisco PGW 2200 Softswitch software. There are two versions of
this disk, one for each of the supported platform types:
–
Cisco Solaris 10 Operating System Jumpstart Disk for
Sparc-based platforms
–
Cisco Solaris 10 Operating System Jumpstart Disk for
Opteron-based platforms
06/06
01/06
• Cisco Solaris 10 Operating Environment CD
This disk contains the following packages:
–
CSCOh020 (MGC Security package)
–
CSCOh021 (Verification Test Suite scripts)
–
CSCOh022 (Solaris 10 patches for Sparc-based platforms)
–
CSCOh023 (DiskSuite installation scripts)
–
CSCOh024 (Log/Spool installation for Sparc-based
platforms)
–
CSCOh026 (Xterm, ftp, ntp, and alarm software installation
for Sparc-based platforms)
–
CSCOh032 (Solaris 10 patches for Opteron-based platforms)
–
CSCOh036 (Xterm, ftp, and ntp installation for
Opteron-based platforms)
3.0(6)