Filter
Top Products
A-9
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
OL-18083-01
Appendix A XECfgParm.dat File Parameters
Understanding the XECfgParm.dat File Format
*.ipAddrLocalB Second local IP address; used for checkpointing and failover
heartbeats if you have active/standby
Cisco PGW 2200 Softswitch hosts.
Note If your configuration does not use an external card,
leave this setting as the default value: 0.0.0.0.
*.ipAddrPeerA First corresponding peer IP address; used for checkpointing
and failover heartbeats.
Note If you have two Cisco PGW 2200 Softswitch hosts
in an active/standby configuration, this value is the
IP address of the second host.
*.ipAddrPeerB Second corresponding peer IP address; used for
checkpointing and failover heartbeats.
Note If your configuration does not use an external card,
leave this setting as the default value, 0.0.0.0.
*.IP_NextHop1
*.IP_NextHop2
*.IP_NextHop3
*.IP_NextHop4
*.IP_NextHop5
*.IP_NextHop6
*.IP_NextHop7
*.IP_NextHop8
Specifies the IP addresses of up to eight next hop counters.
These IP addresses are used when the next hop router IP
addresses on the Cisco PGW 2200 Softswitch hosts do not
match.
Default: 0.0.0.0
Valid values: An IP address expressed in dotted decimal
notation.
*.IUA.maxNasExtNodes Specifies the maximum number of external nodes that can be
defined with an ISDN signaling type of IUA. This number
also represents the maximum number of IUA associations
that can be provisioned.
Valid value: 256
Note Do not change this value.
*.IUA.maxNasPathsPerExtNode Specifies the maximum number of NAS signaling services
that can be assigned to each external node with an ISDN
signaling type of IUA.
Valid value: 112
Note Do not change this value.
*.IUA.maxNasPaths Specifies the maximum number of IUA signaling services
that can be provisioned.
Valid value:1500
Note Do not change this value.
Table A-1 Cisco PGW 2200 Softswitch 9.x XECfgParm.dat File Configuration Parameters
Configuration Parameter Definition