Filter
Top Products
4-2
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
OL-18083-01
Chapter 4 Configuring the Cisco PGW 2200 Softswitch Software
Before You Start
Note For further information on configuring the Cisco PGW 2200 Softswitch software, see the
Cisco PGW 2200 Softswitch Release 9.8 Provisioning Guide.
Before You Start
Before you start, verify the following:
Configuring the Execution Environment
–
Changing XECfgParm.dat File Parameters
–
Changing XECfgParm.dat File Parameters in a Running
Fault Tolerant System
–
Configuring Basic System Information
–
Specifying IP Addresses
–
Configuring Engine Parameters
–
Enabling Call Screening
–
Configuring Call Detail Record File Output
–
Configuring the Clearing Location and Default
Location Parameters
–
Configuring Switchover
–
Initializing the Provisioning Object Manager
on page 4-25
on page 4-26
on page 4-27
on page 4-28
on page 4-30
on page 4-32
on page 4-34
on page 4-35
on page 4-36
on page 4-39
on page 4-41
Configuring SCP Queries
–
Before You Start
–
Configuring the trigger.dat File Attributes
on page 4-42
on page 4-43
on page 4-43
Initializing the Call Screening Database
–
.odbc.ini File Information
–
Setting Up Replication
–
Verifying Database Replication
–
Troubleshooting the Main Memory Database
Replication
on page 4-82
on page 4-83
on page 4-83
on page 4-86
on page 4-87
Configuring Cisco ITP-Ls on page 4-89
Configuring Disk Monitor During Initial Software Configuration on page 4-89
Configuring the Data Dumper on page 4-90
Configuring the Data Dumper to Support Cisco BAMS on page 4-92
Table 4-1 Quick Guide to Configuring the Cisco PGW 2200 Softswitch Software (continued)
Task Detailed Procedures