Filter
Top Products
2-54
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
OL-18083-01
Chapter 2 Installing the Sun Solaris 10 Operating System
Loading the Sun Solaris 10 Operating System
Text similar to the following is displayed:
- Host Name for bge0 -----------------------------------------------------------
Enter the host name which identifies this system on the network. The name
must be unique within your domain; creating a duplicate host name will cause
problems on the network after you install Solaris.
A host name must be at least two characters; it can contain letters, digits,
and minus signs (-).
Host name for bge0:
-------------------------------------------------------------------------------
ESC-2_Continue ESC-6_Help
Caution If you are configuring your system with multiple interfaces, remember that each interface must have a
unique name. Using the same name for multiple interfaces causes the installation script to enter a loop,
forcing you to reboot your system.
Step 11 Type the host name of the target Netra machine, and press ESC-2 to continue.
Note For machine-specific information such as host name, see your notes in “Preparing for Sun
Solaris Operating System and Cisco PGW 2200 Softswitch Software Installation” Table 1-3,
“Machine-Specific Checklist” if you used the checklist to note the host name.
Text similar to the following is displayed:
- IP Address for bge0 -----------------------------------------------------------
Enter the Internet Protocol (IP) address for this network interface. It
must be unique and follow your site's address conventions, or a
system/network failure could result.
IP addresses contain four sets of numbers separated by periods (for example
129.200.9.1).
IP address:
--------------------------------------------------------------------------------
ESC-2_Continue ESC-6_Help
Step 12 Enter the IP address of this interface in dotted decimal format and press ESC-2 to continue.
Note See “Machine-Specific Checklist” in Table 1-3 if you used the checklist to record the IP address.
Text similar to the following is displayed:
- Subnet for bge0 --------------------------------------------------------------
On this screen you must specify whether this system is part of a subnet. If
you specify incorrectly, the system will have problems communicating on the
network after you reboot.
> To make a selection, use the arrow keys to highlight the option and
press Return to mark it [X].